All Issue

2018 Vol.34, Issue 7 Preview Page

Research Article

Investigation of Axially Loaded Jacked Pile Behavior by Pile Load Test

말뚝재하시험을 통한 압입강관말뚝의 연직지지거동 분석

Sung-Ha Baek1
,
Eun-Su Do2
,
Seok-Jung Kim3*
백 성하1
,
도 은수2
,
김 석중3*
1Dept. of Civil & Environmental Engrg., Gachon Univ.
2Infra Engrg. Team, SK Eng. & Construction Co.
3Seismic Safety Research Center, Korea Inst. of Civil Eng. and Building Tech.
1가천대학교 토목환경공학과
2SK건설 인프라 설계팀
3한국건설기술연구원 지진안전연구센터
* Corresponding Author
31 July 2018. pp. 39-49
PDF XML Citation
Abstract

Jacked pile that involves the use of hydraulic jacks to press the piles into the ground is free from noise and vibration, and is possibly installed within a limited construction area. Thus, as an alternative to conventional pile driving methods, pile jacking could become widely accepted for the construction projects in urban area (e.g., reconstruction or remodeling construction projects). Great concern has arisen over the prediction of axially loaded jacked pile behavior. Against this background, a series of pile load tests were hence conducted on a jacked steel pipe pile installed in weathered zone (i.e., weathered soil and weathered rock). From the test results, base resistance and shaft resistance for each test condition were evaluated and compared with the values predicted by the previous driven pile resistance assessment method. Test results showed that the previous driven pile resistance assessment method highly underestimated both the base and shaft resistances of a jacked pile; differences were more obviously observed with the shaft resistance. The reason for this discrepancy is that a driven pile normally experiences a larger number of loading/unloading cycles during installation, and therefore shows significantly degraded stiffness of surrounding soil. Based on the results of the pile load tests, particular attention was given to the modification of the previous driven pile resistance assessment method for investigating the axially loaded jacked pile behavior.

Keywords
Jacked pile
Steel Pipe pile
Pile load test
Bearing capacity
Weathered zone

유압잭을 통해 지반에 압입 시공되는 압입강관말뚝은 소음 및 진동을 적게 발생시켜 도심지 공사에 적합한 기초형식으로 알려져 있다. 특히 협소한 공간에서 시공이 용이하여 리모델링 혹은 수직증축 공사에 널리 활용될 수 있을 것으로 기대되지만, 연직지지거동이 명확히 규명되지 않아 제한적으로만 적용되고 있는 실정이다. 본 연구에서는 압입강관말뚝의 연직지지거동을 평가하기 위하여 국내의 대표적인 지층인 풍화토 및 풍화암 지반에서 말뚝재하시험을 수행하였다. 재하시험 결과를 통해 각 시험조건 별 주면지지력 및 선단지지력을 평가하였고 이를 항타말뚝을 대상으로 제안된 지지력 평가식과 비교분석하였다. 그 결과, 항타말뚝을 대상으로 제안된 평가식을 통한 예측값은 압입강관말뚝의 주면지지력 및 선단지지력을 각각 57.2% 및 33.8% 과소평가 하는 것으로 나타났다. 이는 기존의 지지력 평가식이 단단한 풍화토 및 풍화암층의 강도를 적절히 고려하지 못하며, 항타공법에 비해 압입공법을 통한 말뚝 설치 시 말뚝주변 지반 교란에 따른 지지력 감소가 더 작게 나타나기 때문으로 판단된다. 추가적으로, 기존의 지지력 평가식을 재하시험 결과를 바탕으로 개선하여 압입강관말뚝의 연직지지거동 평가 및 연직지지력 산정 시 활용 가능하도록 하였다.

References
1
ASCE 20-96 (1997), Standard Guideline for the Design and Installation of Pile Foundations, American Society of Civil Engineers.
2
ASTM D 1143-81 (1981), Standard Test Method for Piles Under Static Axial Compresive Load, American Society for Testing and Materials.
3
Burland, J.B. (1973), “Shaft Friction of Piles in Clay: A Simple Fundamental Approach”, Ground Engineering, Vol.6, No.3, pp. 30-42.
4
Chow, F.C. (1995), “Field Measurements of Stress Interactions between Piles in Sand”, Ground Engineering, Vol.28, No.6, pp.36-40.
5
Chow, F.C. (1997), Investigations into the behaviour of displacement piles for offshore foundations, PhD thesis, Imperial College, University of London.
6
Davisson, M.T. (1973), “High Capacity of Piles”, Proceedings of Lecture Series on Innovation in Foundation Construction, Illinois section, Chicago, pp.81-112.
7
Fellenius, B.H. (1990), Guidelines for the interpretation and analysis of the static loading test, Deep Foundation Institute, pp.4-7.
8
FHWA (1996), Load Transfer for Drilled Shafts in Intermediate Geomaterials, Publication No. FHWA-RD-95-172, Federal Highway Administration.
9
FHWA (1999), Drilled Shafts: Construction Procedures and Design Methods, Publication No. FHWA-IF-99-025, Federal Highway Administration.
10
Hansen, B.J. (1963), “Discussion on Hyperbolic Stress-strain Response: Cohesive Soils”, J. of the Soil Mechanics and Foundation Division, ASCE, Vol.89, No.SM4, pp.241-242.
11
Heerema, E.P. (1980), “Predicting Pile Driveability: Heather as an Illustration of the Friction Fatigue Theory”, Ground Engineering, Vol.13, pp.15-37.
12
KGS (2009), Standard Guideline for the Design of Foundation Structures, Korean Geotechnical Society (in Korean).
13
Kim, S.R., Chung, S.G., and Dzung, N.T., “Determination of True Resistance from Load Transfer Test Performed on a PHC Pile”, J. of the Korean Geotechnical Society, Vol.22, No.11, pp.113-122 (in Korean).
14
KOSA (2005), Guideline for the Design and Installation of Steel Pipe Pile, Korea Iron & Steel Association (in Korean).
15
Kwon, O.S. (1998), Experimental study on the shear strength and deformation characteristics of weathered soil, PhD thesis, Department of Civil and Environmental Engineering, Seoul National University (in Korean).
16
Lee, S.H. (2015), Systematization for evaluating ultimate bearing capacity of drilled shaft socketed in weathered zone, Master thesis, Department of Civil and Environmental Engineering, Seoul National University.
17
Lee, S.G. (1993), “Weathering of Granite”, J. of the Geological Society of Korea, Vol.29, No.4, pp.369-413.
18
Lee, J.H., Kim, W.C., Seo, D.D., and Nam, H.W. (2006), “Case Study on Design of Axially Loaded Drilled Shafts in Intermediate Geomaterials(II)”, Journal of Korea Geo-Environmental Society, Vol.7, No.1, pp.19-28 (in Korean).
19
Lehane, B.M. (1992), Experimental investigations of pile behaviour using instrumented field piles, PhD thesis, Imperial College, University of London.
20
Lehane, B.M., Jardine, R.J., Bond, A.J., and Frank, R. (1993), “Mechanisms of Shaft Friction in Sand from Instrumented Pile Tests”, ASCE J. of Geotechnical Engineering, Vol.119, No.GT1, pp.19-35.
10.1061/(ASCE)0733-9410(1993)119:1(19)
21
MLTMA (2008), Determination of Resistance Factors for Foundation Structure Design by LRFD, Ministry of Land, Transportation and Maritime Affairs (in Korean).
22
Meyerhof, G.G. (1976), “Bearing Capacity and Settlements of Pile Foundations”, J. of Geotechnical Engineering Division, ASCE, Vol.102, No.GT3, pp.197-228.
23
Seoul (2006), Standard Guideline for the Site Exploration, Seoul Metropolitan Government (in Korean).
24
Vesic, A.S. (1970), “Test on Instrumented Piles, Ogeechee River Site”, J. of the Soil Mechanics and Foundation Division, ASCE, Vol. 96, No. SM2, pp. 561-584.
25
White, D.J. and Lehane, B.M. (2004), “Friction Fatigue on Displacement Piles in Sand”, Geotechnique, Vol.54, No.10, pp.645-658.
10.1680/geot.2004.54.10.645
26
Yang, J. and Li, X.S. (2004), “State-dependent Strength of Sands from the Perspective of Unified Modeling”, J. of the Geotechnical and Geoenvironmental Engineering, ASCE, Vol.130, No.2, pp. 186-198.
10.1061/(ASCE)1090-0241(2004)130:2(186)
27
Yang, J., Tham, L.G., Lee, P.K.K., Chan, S.T., and Yu, F. (2006), “Behavior of Jacked and Driven Piles in Sandy Soil”, Geotechnique, Vol.56, No.4, pp.245-259.
10.1680/geot.2006.56.4.245
Information
  • Publisher :The Korean Geotechnical Society
  • Publisher(Ko) :한국지반공학회
  • Journal Title :Journal of the Korean Geotechnical Society
  • Journal Title(Ko) :한국지반공학회 논문집
  • Volume : 34
  • No :7
  • Pages :39-49
  • Received Date : 2018-06-01
  • Revised Date : 2018-06-19
  • Accepted Date : 2018-06-20
  • DOI :https://doi.org/10.7843/kgs.2018.34.7.39
Journal Informaiton Journal of the Korean Geotechnical Society Journal of the Korean Geotechnical Society
Archives
: Vol.23~28 (2007~2012)
  • NRF
  • KOFST
  • KISTI Current Status
  • KISTI Cited-by
  • crosscheck
  • orcid
  • open access
  • ccl
Journal Informaiton Journal Informaiton - close