All Issue

2022 Vol.38, Issue 12
A Study on the Suitability of CLSM Mixing Ratio Considering Dry Shrinkage

건조수축을 고려한 유동성 채움재 배합비 적합성에 관한 연구

Byeong-Won Jeon1
,
Byeong-Jun Kim2*
전 병원1
,
김 병준2*
1Senior Manager, Busan Metropolitan City Hall.
2Member, Deputy, Geowon Engrg. Corporation
1비회원, 부산광역시 도시계획국 주무관
2정회원, ㈜거원엔지니어링 차장
*Corresponding Author
31 December 2022. pp. 7-17
PDF XML Citation
Abstract

The ratios of water and controlled low-strength materials (CLSM) were selected as 1:0.4, 1:0.6, 1:0.8, 1:1.0, and 1:1.2 to minimize the construction and long-term decrease in uniaxial compressive strength due to dry shrinkage through the combination of water, CLSM, and expansion agent. Approximately 2% and 5% of the expansion agent were added for each blending condition. As a result, it was found that the compressive strength decreased and the expandability increased as the specific gravity of the water increased. In addition, it was confirmed that the compressive strength increased rapidly up to 15 days of age compared to the CLSM used in the field. However, the compressive strength decreased compared to the 15 days of the age as of the 28 days of the age. It showed engineering characteristics similar to CLSM generally used in the field. Therefore, the water and the CLSM were mixed at a ratio of 1:0.8, and the field test was performed by adding 5% of an expansion agent. As a result, 28 days after age, the cavity waveform was observed using the handy GPR exploration system, and it was found that cavity waveform was relaxed or disappeared.

Keywords
Controlled low strength material
Expansion
Ground penetrating rader
Uniaxial compressive strength

본 연구에서는 물과 유동성 채움재, 팽창제의 배합을 통하여 건조수축으로 인한 시공 불량과 장기적인 압축강도 저하를 최소화 하고자 물과 유동성 채움재를 각각 1:0.4, 1:0.6, 1:0.8, 1:1.0, 1:1.2로 선정하였으며, 각각의 배합 조건당 팽창제 2%, 5%를 첨가하였다. 그 결과 모든 조건에서 물의 비중이 증가할수록 압축강도가 감소하는 경향을 보임과 동시에 팽창성은 증가하는 것으로 나타났다. 또한, 현장에 사용되는 기성품(유동성 채움재) 대비 재령 15일까지의 압축강도가 급격하게 증가하는 것을 확인하였다. 하지만 재령 28일 기준 압축강도가 재령 15일 대비 급격하게 감소하였으며, 현장에 사용되고 있는 기성품(유동성 채움재)와 유사한 공학적 특성을 나타냈다. 따라서 다양한 배합비 산정 시험결과 중 가장 양호한 압축강도와 팽창성을 보인 조건(물과 채움재를 1:0.8로 배합, 팽창제 5% 첨가)을 적용하여 현장시험을 수행하였으며, 그 결과 재령 28일 경과 후 핸디형 GPR 탐사 시스템을 활용하여 공동 파형을 관찰한 결과 공동 파형이 완화 또는 사라진 것으로 나타났다.

References
1
ACI Committee 229 (1994), Controlled Low Strength Materials (CLSM), American Concrete Institute, 229R-2, pp.1-12.
2
Han, M. S. (2017), A Risk Assessment of Ground Subsidence by GPR and CCTV Investigation, Ph.D. Thesis, Seoul National University of Science and Technology, 161p.
3
Chemius (2022), Chemi-FHL of Construction, https://www.chemius.co.kr.
4
Han, Y. S. (2018), "Numerical Analysis and Exploring of Ground Condition during Groundwater Drawdown Environment in Open-Cut Type Excavation", Journal of the Korean Geotechnical Society, Vol.34, No.11, pp.93-105.
5
Jang, S. S. (2020), Engineering Characteristics of Controlled Low Strength Materials using Paper Sludge Ash, Master's Thesis, Korea National University of Transportation, 45p.
6
Kim, J. H., Cho, S. D., Kong, J. Y., Jung, H. S., and Chun, B. S. (2010), "Curing Characteristics of Controlled Low Strength Material Made with Coal Ashes", Journal of the Korean Geo-Environmental Society, Vol.11, No.11, pp.77-85.
7
Kim, S. C. (2019), Engineering Characteristics and Applicability of Controlled Low Strength Material according to Type of Fly Ash, Ph.D. Thesis, Kyungpook National University, 121p.
8
Lee, D. Y. and Cho, N. K. (2016), "Understanding of Subsurface Cavity Mechanism due to the Deterioration of Buried Pipe", Journal of the Korean Geotechnical Society, Vol.32, No.12, pp.33-43. 10.7843/kgs.2016.32.12.33
9
Lee, I. H. (2020), Analysis of Engineering Characterisitics of CLSM by Utilizing Fly Ash and Paper Sludge Ash, Master's Thesis, Incheon National University, 63p.
10
Lee, S. Y. (2016), A Study on the Experimentation a Controlled Low Strength Material using Industrial By-Products, Master's Thesis, Dong Yang University, 87p.
11
Lee, S. Y., Lim, D. S., Jung, H. S., Kong, J. Y., and Kwon, S. H. (2018), "Development and Field Application of Fluid Filler for Emergency Recovery using Bottom Ash and Gypsum, Journal of the Korean Geo-Environmental Society, Vol.13, No.3, pp.22-31.
12
Park, C. H., Won, K. S., Byun, J. H., Min, D. H., and Yoon, H. K. (2013), "The Investigation of Alluvium by Using Electrical Resistivity, Seismic Survey and GPR", Journal of the Korean Geotechnical Society, Vol.29, No.9, PP.17-29. 10.7843/kgs.2013.29.9.17
13
Park, J. H. (2004), Deformation Behavior of Underground Pipe with CLSM, Master's Thesis, Kyung Sung University, 62p.
14
Park, J. W. (2015), A Study on Characteristics of Flowable Fill using Calcium Carbonate By-Product of CO2 Collection, Master's Thesis, Seoul National Unversity of Science and Technology, 52p.
Information
  • Publisher :The Korean Geotechnical Society
  • Publisher(Ko) :한국지반공학회
  • Journal Title :Journal of the Korean Geotechnical Society
  • Journal Title(Ko) :한국지반공학회 논문집
  • Volume : 38
  • No :12
  • Pages :7-17
  • Received Date : 2022-09-05
  • Revised Date : 2022-11-25
  • Accepted Date : 2022-11-25
  • DOI :https://doi.org/10.7843/kgs.2022.38.12.7
Journal Informaiton Journal of the Korean Geotechnical Society Journal of the Korean Geotechnical Society
Archives
: Vol.23~28 (2007~2012)
  • NRF
  • KOFST
  • KISTI Current Status
  • KISTI Cited-by
  • crosscheck
  • orcid
  • open access
  • ccl
Journal Informaiton Journal Informaiton - close