Abstract
References
2.Byrne, B.W. and Houlsby, G.T. (2002), “Experimental Investigations of Response of Suction Caissons to Transient Vertical Loading”, Journal of Geotechnical and Geoenvironmental Engineering, 2002, 11, pp.926-936. 3.Choi, G.N. and Yoo, C.S. (2011), “Urban Excavation – Induced Ground Movement in Water Bearing Ground Using Stress-Pore Pressure Coupled Analysis”, Journal of Korean Geotechnical Society, Vol. 27, No.5, pp.17-31. 4.Colliat, J.L. and Dendani, H. (2002), “Girassol: Geotechnical Design Analyses and Installation of the Suction Anchors”, Proceedings, SUT International Conference on Offshore Site Investigation and Geotechnics, London, November 26-28. 5.Gourvence, S. and Barnett, S. (2011), “Undrained failure envelope for skirted foundations nder general loading”, Geotechnique 61, No. 3, pp.263-270. 6.Hefer, P. (1998), “Oil and Gas Floating Facility to be Anchored in 390m Deep Timor Sea”, Civil Engineers Australia, December 1998. 7.Huang, J., Jianchun, C., Jean, M.E., and Audibert, M. (2003), “Geotechnical Design of Suction Caisson In Clay”, Proceedings of The Thirteenth (2003) International Offshore and Polar Engineering Conference Honolulu, Hawaii, USA, May 25-30, 2003. 8.Kang, S.O. (2005), “Establishment of Suction Pile on Underwater Sand Ground and Clay Ground”, master thesis, Sunchon National Univ. 9.Ke, W., Mingyue, M., and Rong, C. (2010), “Numerical Analysis of Cyclic Bearing Capacity of Suction Bucket Foundation Based on Elasto-plastic FEM”, Electronic Journal Geotechnical Engineering, Vol.15, pp.1-13. 10.Kim, D.J., Choo, Y.W., Kim, S.R., Kim, J.H., Choi, H.Y., Kim, D.S., Lee, M.S., and Park, Y.H. (2013), “Bearing Capacity of a Monopod Bucket Foundation for Offshore Wind Towers – Centrifuge and Numerical Modeling”, Journal of Korean Geotechnical Society, Vol.29, No.4 pp.23-32. 11.Kim, S.R., Jeong, J.U., Oh, M.H., and Kwon, O.S. (2012), “Analysis of the Bearing Behavior of a Tripod Bucket Installed in Clay”, Journal of Korean Society of Civil engineers, Vol.32, No.3C pp.105-111. 12.Kim, Y.S. and Jang, Y.S. (2011), “Analysis of Load Capacity and Deformation Behavior of Suction Pile Installed in Sand”, Journal of Korean Geotechnical Society, Vol.27, No.11 pp.27-37. 13.Lee, J.H., Kim, D.W., Chung, M.K., Kwak, K.S., and Jung, Y.H. (2011), “Numerical Analysis of the Suction Pile Behavior with Different Lateral Loading Locations”, Journal of Korean Geotechnical Society, Vol.27, No.4, pp.67-76. 14.Lee, C.H., Jeoung, J.U., and Kim, S. R. (2011), “Numerical Analysis on Bearing Capacity of a Suction Bucket in Clay”, Journal of Korean Geotechnical Society, Vol. 27, No.10 pp.25-33. 15.Luke, A.M., Rauch, A.F., Olson, R. E., and Mecham, E. C. (2005), “Components of suction caisson capacity measured in axial pullout tests”, Ocean Engineering 32 (2005) pp.878-891. 16.Sheng, D., Eigenbrod, K.D., and Wriggers, P. (2005), “Finite element analysis of pile installation using large-slip frictional contact”, Computers and Geotechnics 32 (2005) pp.17-26.
Information
- Publisher :The Korean Geotechnical Society
- Publisher(Ko) :한국지반공학회
- Journal Title :Journal of the Korean Geotechnical Society
- Journal Title(Ko) :한국지반공학회 논문집
- Volume : 30
- No :1
- Pages :103-116
- Received Date : 2014-01-06
- Revised Date : 2014-01-14
- Accepted Date : 2014-01-14
- DOI :https://doi.org/10.7843/kgs.2014.30.1.103


Journal of the Korean Geotechnical Society







